Barcus-berry 1457XL Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Instruments de musique Barcus-berry 1457XL. Barcus Berry 1457XL User Manual Manuel d'utilisatio

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 15
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 0
~1455-3, 1457, 1457XL~
Acoustic Guitar
Transducers
Vue de la page 0
1 2 3 4 5 6 ... 14 15

Résumé du contenu

Page 1 - Transducers

~1455-3, 1457, 1457XL~Acoustic GuitarTransducers

Page 2 - Made in the U.S.A

push the Fas-Jac back into the guitar until accessiblethrough the sound hole and adjust the position of the nuton the body of the Fas-Jac. Pull the Fa

Page 3

tighten the cap while holding the body of the Fas-Jacwith a screw driver inserted into the slot in the end of theFas-Jac.INSTALLATION PROCEDURES FOR T

Page 4

(6) Adhesive mounting strips for the transducer(3) Adhesive mounting strips for output jack(1) Instruction sheetThe transducer is affixed to the top o

Page 5

the pickup beneath the strings, (parallel to and immedi-ately adjacent to the front edge of the bridge) and pressfirmly against the top of the guitar.

Page 7

Limited WarrantyThis Barcus-Berry product is warranted for a period of one (1) year from the date of purchaseagainst defects in workmanship and parts.

Page 8

Made in the U.S.A.This Barcus-Berry product is manufactured in theUnited States. It is designed to satisfy the most rigorous demands of the profession

Page 9

T he Barcus-Berry INSIDER and OUTSIDERare professional quality, high-performance transducersdesigned for mounting within or on any flat-top acoustic(s

Page 10

the true, natural sound is required for either reinforce-ment or direct-feed recording applications. The trans-ducer is fully shielded against the hum

Page 11

provides assurance of long-continued service. For out-standing performances and dependability, you canalways rely upon Barcus-Berry, the world’s leadi

Page 12

Installation for the 1455-3 InsiderTO INSTALL THE TRANSDUCER:The bottom surface of the INSIDER is covered with aspecial foam strip adhesive by which i

Page 13

into the instrument through the soundhole and position itparallel to and directly beneath the bridge (immediatelyin front of the string pins), pressin

Page 14

TO INSTALL AND CONNECT THE OUTPUT JACK:Tools required:(1) 16” to 18” length of 1/4” diameter rod (e.g. wooden dowel)5/16” screwdriver9/16” open-end wr

Page 15 - Limited Warranty

diameter hole through the end block where the Fas-Jacis to be installed.4) Insert the 1/4” diameter rod into the guitar through thehole in the end blo

Modèles reliés 1457 | 1455-3 |

Commentaires sur ces manuels

Pas de commentaire